How To Proceed With Troubleshooting [06/2015 - ]: Procedure

Result

Result:  1

NEXT 

See step  2

Result

Result:  1

NEXT 

See step  3

1. Measure the battery voltage.

   Standard Voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  4

1. Check if CAN communication DTCs are output.

   Refer to DIAGNOSIS SYSTEM [06/2015 - ]

   Result

   Result	Proceed to
   CAN communication DTCs are not output.	A
   CAN communication DTCs are output.	B

Result:  2

B 

GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [06/2015 - ] 

Result:  1

A 

See step  5

1. Check for DTCs.

   Refer to DTC CHECK / CLEAR [06/2015 - ] 

   Body Electrical > Combination Meter > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output.	A
   DTCs are output.	B

Result:  2

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [06/2015 - ]  

Result:  1

A 

See step  6

Result

Result:  1

NEXT 

See step  7

Result

Result:  1

NEXT 

See step  8

1. Refer to Problem Symptoms Table.

   Refer to PROBLEM SYMPTOMS TABLE [06/2015 - ] 

   Result

   Result	Proceed to
   Fault is not listed in Problem Symptoms Table.	A
   Fault is listed in Problem Symptoms Table.	B

Result:  2

B 

GO TO PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [06/2015 - ]  

Result:  1

A 

See step  9

Result

Result:  1

NEXT 

See step  10

Result

Result:  1

NEXT 

See step  11

Result

Result:  1

NEXT 

END