Abnormal Sound During Door Glass Opening/Closing [07/2015 - ]: Procedure
- DIAGNOSTIC PROCEDURE
Noise type Time of occurrence Possible cause Location of noise Action Clanking noise Door glass begins to move Insufficiently tightened installation screw between the door glass and carrier plate. Between door glass lower edge and carrier plate. Securely tighten the installation screw. Groaning noise (Sound increases due to use) While door glass is operating Vibration caused by wear on the resin part from cable twisting due to use of the power window regulator.
HINT:- Noise does not occur if a roller is equipped to power window regulator resin part.
Power window regulator Replace the power window regulator.
Refer to REMOVAL [07/2015 - ]
Refer to REMOVAL [07/2015 - ]Whining noise Gear inside power window motor is deformed due to use. Gear in power window motor Replace the power window motor.
Refer to REMOVAL [07/2015 - ]
Refer to REMOVAL [07/2015 - ]Clicking noise (Periodic noise) Result
Proceed to NEXT Result: 1
NEXT
END