DTC U2300-51: Central Configuration not programmed [07/2015 - ]: Procedure

1. Using the Techstream, perform the combination meter configuration (using As-Built data).

   Refer to INSPECTION [07/2015 - ]

2. Clear the DTC for the combination meter using the Techstream.

   Refer to DTC CHECK / CLEAR [07/2015 - ]

   Body Electrical > Instrument Cluster > Clear DTCs 

3. Retrieve the combination meter DTCs using the Techstream. (See 09-02B-7 DTC INSPECTION [combination meter].)

   Refer to DTC CHECK / CLEAR [07/2015 - ]

   Body Electrical > Instrument Cluster > Trouble Codes 

4. Is the same DTC displayed?

   Result

   Proceed to
   Yes
   No

Result:  2

Yes 

See step  5

Result:  1

No 

See step  3

1. Clear the DTC for the combination meter using the Techstream.

   Refer to DTC CHECK / CLEAR [07/2015 - ]

   Body Electrical > Instrument Cluster > Clear DTCs 

2. Retrieve the combination meter DTCs using the Techstream.

   Refer to DTC CHECK / CLEAR [07/2015 - ]

   Body Electrical > Instrument Cluster > Trouble Codes 

3. Is the same DTC displayed?

   Result

   Proceed to
   Yes
   No

Result:  2

Yes 

See step  4

Result:  1

No 

See step  3

1. Are any other DTCs displayed?

   Result

   Proceed to
   Yes
   No

Result:  1

No 

DTC TROUBLESHOOTING COMPLETED. 

Result:  2

Yes 

REPAIR OR REPLACE THE MALFUNCTIONING PART ACCORDING TO THE APPLICABLE DTC TROUBLESHOOTING. Refer to  DIAGNOSTIC TROUBLE CODE CHART [07/2015 - ] 

1. Refer to REMOVAL [07/2015 - ]
2. Then go to the next step.

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  3

1. Refer to INSPECTION [07/2015 - ]
2. Then go to the next step.

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  2