DTC Check / Clear [05/2014 - ]

CHECK DTC
1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / DTC.
5. Check DTCs and then write them down.
  HINT:
  
  Refer to the Techstream operator's manual for further details.
6. Confirm the details of the DTCs.
CLEAR DTC
1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON (do not start the engine).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / DTC / Clear.
  HINT:
  
  Refer to the Techstream operator's manual for further details.
5. Clear DTCs by pressing the YES button on the tester.
  HINT:
  
  Refer to the Techstream operator's manual for further details.