Customize Parameters [05/2014 - ]

CUSTOMIZE METER / GAUGE SYSTEM

Customizing with the Techstream

Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Customize Setting / Combination Meter / Warning.

Select the setting by referring to the table below.

NOTE:

Be sure to record the current value before customizing.

WARNING

Tester Display	Default	Content	Setting	Relevant ECU
Key Remind Sound	NORMAL	Function to change the frequency of the key reminder buzzer.	NORMAL, FAST or SLOW	Combination meter assembly
Tail Remind Buzzer	ON	Function to change the Tail Remind Buzzer.	ON or OFF	Combination meter assembly
Driver Side Seatbelt Warning Buzzer*	ON	Function to turn on/off the seat belt warning buzzer	ON or OFF	Combination meter assembly
Front Passenger Side Seatbelt Warning Buzzer*	ON	Function to change the seat-belt warning buzzer.	ON or OFF	Combination meter assembly

*: This setting is only valid for the buzzer which sounds at 20 km/h (12 mph) or more

Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Customize Setting / Combination Meter / Air Conditioner.

Select the setting by referring to the table below.

NOTE:

Be sure to record the current value before customizing.

AIR CONDITIONER

Tester Display	Default	Content	Setting	Relevant ECU
Ambient Temperature Adjustment	0°C (0°F)	Function to change the display temperature to match the actual temperature.	+3°C (+5.4°F) +2°C (+3.6°F), +1°C (+1.8°F), 0°C (0°F), -1°C (-1.8°F), -2°C (-3.6°F) or 3°C (-5.4°F)	Combination meter assembly