Entire Combination Meter Does Not Operate [05/2014 - ]: Procedure

1. Disconnect the D7 combination meter assembly connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to Combination Meter Assembly)

2. Measure the voltage according to the value(s) in the chart below.

   Standard Voltage

   Tester Connection	Switch Condition	Specified Condition
   D7-1 (B) - Body ground	Always	11 to 14 V
   D7-2 (IG+) - Body ground	Ignition switch ON	11 to 14 V

3. Measure the resistance according to the value in the chart below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   D7-20 (ES1) - Body ground	Always	Below 1 Ω
   D7-40 (ES2) - Body ground	Always	Below 1 Ω

4. Reconnect the D7 combination meter assembly connector.

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   2