DTC U0129: Lost Communication with Skid Control ECU [08/2013 - ]: Procedure
- CONFIRM DTC OUTPUT
- Connect a Techstream to the DLC3.
- Turn the ignition switch to ON and turn the Techstream on.
- Check for DTCs and note any codes that are output. Refer to DTC CHECK / CLEAR [08/2013 - ] .
- Clear the DTC. Refer to DTC CHECK / CLEAR [08/2013 - ] .
- Recheck for DTC. Refer to DTC CHECK / CLEAR [08/2013 - ]
.RESULT
Result Proceed to DTC output A DTC not output B
B → See step 3
A → See step 2
- GO TO CAN COMMUNICATION SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2013 - ]
- USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2013 - ]