How To Proceed With Troubleshooting [11/2013 - ]

HINT: 

• Use these procedures to troubleshoot the meter / gauge system.
• *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 

   NEXT: Go to next step 

2. INSPECT BATTERY VOLTAGE 

   Standard voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the battery before proceeding.

   NEXT: Go to next step 

3. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM (CAN)* 
   1. Use the Techstream to check if the CAN communication system is functioning normally.

      Result

      Result	Proceed to
      CAN DTC is not output	A
      CAN DTC is output	B

      B → GO TO CAN COMMUNICATION SYSTEM 

      A: Go to next step 

4. PROBLEM SYMPTOMS TABLE 

   Result

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B → Go to step 6 

   A: Go to next step 

5. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. DATA LIST / ACTIVE TEST. Refer to DATA LIST / ACTIVE TEST [11/2013 - ] 
   2. Terminals of ECU. Refer to TERMINALS OF ECU [11/2013 - ] 
   3. On-vehicle Inspection. Refer to ON-VEHICLE INSPECTION [11/2013 - ]

      NEXT: Go to next step 

6. REPAIR OR REPLACE 

   NEXT: Go to next step 

7. CONFIRMATION TEST 

   NEXT → END