LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2014 >> xB Automatic Trans >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter & Gauge System (Diagnostics - Introduction) >> Meter / Gauge System >> Data List / Active Test [11/2013 - ] >> Data List / Active Test [11/2013 - ]

Data List / Active Test [11/2013 - ]

  1. DATA LIST 

    HINT: 

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / (desired system) / Data List.
    5. According to the display on the Techstream, read the Data List.
      COMBINATION METER

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Tail Relay SW Taillight relay/ ON or OFF ON: Headlight dimmer switch (Light control switch) → TAIL
      OFF: Headlight dimmer switch (Light control switch) → OFF      		 -
      Tail Cancel SW Tail cancel switch/ ON or OFF ON: Headlight dimmer switch (light control switch) TAIL or HEAD
      OFF: Headlight dimmer switch (light control switch) OFF      		 -
      ODO/TRIP Change SW ODO/TRIP switch/ ON or OFF ON: ODO/TRIP switch pushed
      OFF: ODO/TRIP switch not pushed      		 -
      Timer SW on Combination Meter CLOCK switch/ ON or OFF ON: CLOCK switch pushed
      OFF: CLOCK switch not pushed      		 -
      Vehicle Speed Meter Vehicle speed/ Min.: 0 (0), Max.: 255 (158) Approximately same as actual vehicle speed (When vehicle is being driven) Unit: km/h (mph)
      Engine Rpm Engine speed/ Min.: 0, Max.: 12750 Approximately same as actual engine speed (when engine is running) Unit: rpm
      Coolant Temperature Engine coolant temperature/ Min.: 0 (32), Max.: 127.5 (261.5) After warming up: 75 to 105 (167 to 221) Unit: °C (°F)
      Multi Display Select Switch DISP switch/ ON or OFF ON: DISP switch pushed
      OFF: DISP switch not pushed      		 -
      +B Voltage Battery voltage/ Min.: 0, Max.: 25.5 Between 1 V and 14 V Unit: V
      Integrated value for Oil Maintenance*1 Oil maintenance information integrated value/ Min.: 0, Max.: 25500 (miles) Driving distance after performing oil maintenance resetting procedure displayed If the value is 5000 (miles) or more, perform the oil maintenance resetting procedure after changing the oil.
      Fuel Input Fuel input signal/ Min.: 0, Max.: 127.5 Fuel sender input value Unit: Liters
      Ambient Temperature Ambient temperature/ Min.: - 40 (-40), Max.: 87.5 (189.5) Same as outside temperature Unit: °C (°F)
      Rheostat value Rheostat value/ Min.: 0 Max.: 100 Light control rheostat switch is dark → bright Unit: %
      Communication ECM/Meter DTC 1 ECM communication stop history/ Rec or Unrec Displays DTC history -
      ECM ODO (History 1) ECM odometer history/ Min.: 0, Max.: 999999 With history : 0 to 999999
      Without history : FFFFFFh      		 -
      Communication ECM/Meter DTC 2 ECM communication stop history/ Rec or Unrec Displays DTC history -
      ECM ODO (History 2) ECM odometer history/ Min.: 0, Max.: 999999 With history : 0 to 999999
      Without history : FFFFFFh      		 -
      Communication ECM/Meter DTC 3 ECM communication stop history/ Rec or Unrec Displays DTC history -
      ECM ODO (History 3) ECM odometer history/ Min.: 0, Max.: 999999 With history : 0 to 999999
      Without history : FFFFFFh      		 -
      Communication ABS/Meter DTC 1 Skid control ECU communication stop history/ Rec or Unrec Displays DTC history -
      ABS/VSC ODO (History 1) Skid control ECU odometer history/ Min.: 0, Max.: 999999 With history : 0 to 999999
      Without history : FFFFFFh      		 -
      Communication ABS/Meter DTC 2 Skid control ECU communication stop history/ Rec or Unrec Displays DTC history -
      ABS/VSC ODO (History 2) Skid control ECU odometer history/ Min.: 0, Max.: 999999 With history : 0 to 999999
      Without history : FFFFFFh      		 -
      Communication ABS/Meter DTC 3 Skid control ECU communication stop history/ Rec or Unrec Displays DTC history -
      ABS/VSC ODO (History 3) Skid control ECU odometer history/ Min.: 0, Max.: 999999 With history : 0 to 999999
      Without history : FFFFFFh      		 -
      Key Remind Sound Key remind sound/ FAST, NORMAL or SLOW Display key reminder buzzer speed setting -
      Driver Side Seatbelt Warning Buzzer Driver side seat belt warning buzzer/ ON or OFF ON: Driver side seat belt warning buzzer ON
      OFF: Driver side seat belt warning buzzer OFF      		 -
      P-Seatbelt Warning Buzzer Front passenger side seat belt warning buzzer/ ON or OFF ON: Front passenger side seat belt warning buzzer ON
      OFF: Front passenger side seat belt warning buzzer OFF      		 -
      Number of Trouble Code Number of trouble codes/ MIN.: 0, MAX.: 255 Number of DTCs will be displayed -
      • *1: for U.S.A.
      MAIN BODY

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Key Unlock Warning SW Unlock warning switch signal/ ON or OFF ON: Key is in ignition key cylinder
      OFF: No key is in ignition key cylinder      		 -
      D Door Courtesy SW Driver side door courtesy switch signal/ ON or OFF ON: Driver side door is open
      OFF: Driver side door is closed      		 -
  2. PERFORM ACTIVE TEST 

    HINT: 

    Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
    5. According to the display on the tester, perform the Active Test.
      COMBINATION METER

      Tester Display Test Part Control Range Diagnostic Note
      Speed Meter Operation Speedometer 0/40/80/120 mph Vehicle is stopped and ignition switch ON
      Acceptable range (mph): [Control range → Speedometer display]
      • 40 → 39.0 to 42.6
      • 80 → 79.3 to 83.9
      • 120 → 119.7 to 125.1
      0/40/80/120/160/200 km/h Vehicle is stopped and ignition switch ON
      Acceptable range (km/h): [Control range → Speedometer display]
      • 40 → 38.2 to 43.5
      • 80 → 78.4 to 84.8
      • 120 → 118.8 to 126.0
      • 160 → 159.3 to 167.2
      • 200 → 199.7 to 208.3
      Tachometer Operation Tachometer 0/1000/2000/3000/4000/5000/6000/7000 rpm Vehicle is stopped and ignition switch ON
      Fuel Meter Operation Fuel gauge EMPTY/ 1/2 /FULL Vehicle is stopped and ignition switch ON
      Water Temperature Meter Operation Engine coolant temperature warning light and indicator light LOW: Engine coolant temperature indicator light illuminates.
      NORMAL: Both engine coolant temperature warning light and indicator light turn off.
      HIGH: Engine coolant temperature warning light flashes.      		 Vehicle is stopped and ignition switch ON
      A/T Indicator Operation 1*1 A/T shift indicator P/R/N/D/4 (M/S)/3 (M/S)/2/L Vehicle is stopped and ignition switch ON
      A/T Indicator operation 2*1 A/T shift indicator Es Vehicle is stopped and ignition switch ON
      Indicat. Lamp Airbag Airbag warning light OFF/ON Vehicle is stopped and ignition switch ON
      Indicat. Lamp Doors All Open Door warning light OFF/ON Vehicle is stopped and ignition switch ON
      Front Passenger Side Seat Belt Front passenger side seat belt warning light OFF/ON Vehicle is stopped and ignition switch ON
      Driver Side Seat Belt Driver side seat belt warning light OFF/ON Vehicle is stopped and ignition switch ON
      Indicat. Lamp ABS ABS warning light OFF/ON Vehicle is stopped and ignition switch ON
      Indicat. Lamp Charge Charge warning light OFF/ON Vehicle is stopped and ignition switch ON
      Indicat. Lamp Slip Slip indicator light OFF/ON Vehicle is stopped and ignition switch ON
      Indicat. Lamp Coolant Cool Engine coolant temperature indicator light OFF/ON Vehicle is stopped and ignition switch ON
      Indicat. Lamp Coolant Hot Engine coolant temperature warning light OFF/ON Vehicle is stopped and ignition switch ON
      Indicat. Lamp Fuel Fuel warning light OFF/ON Vehicle is stopped and ignition switch ON
      VSC TRC Indicator TRAC OFF indicator light OFF/ON Vehicle is stopped and ignition switch ON
      Indicat. Tire Pressure Warning System Tire pressure warning light OFF/ON Vehicle is stopped and ignition switch ON
      Indicat. Lamp Cruise CRUISE indicator light OFF/ON Vehicle is stopped and ignition switch ON
      Indicat. Lamp Brake Brake warning light OFF/ON Vehicle is stopped and ignition switch ON
      Indicat. EPS EPS warning light OFF/ON Vehicle is stopped and ignition switch ON
      Indicat. Oil Maintenance*2 Oil maintenance warning light OFF/ON Vehicle is stopped and ignition switch ON
      Indicat. SET SET indicator light OFF/ON Vehicle is stopped and ignition switch ON
      Indicat. Lamp VSC OFF VSC OFF indicator light OFF/ON Vehicle is stopped and ignition switch ON
      Meter Display 1 Meter display ALL/0/1/2/3/4/5/6 Vehicle is stopped and ignition switch ON
      Meter Display 2 Meter display 7/8/9 Vehicle is stopped and ignition switch ON
      • *1: for Automatic Transaxle
      • *2: for U.S.A.
scientia non olet · About LEMON Manuals