DTC P0AC0-123: EV Battery No. 1 Pack Current Sensor "A" Circuit Range / Performance: Procedure
- CHECK DTC OUTPUT (EV BATTERY)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / EV Battery / Trouble Codes.
- Read output DTCs.RESULT
Result Proceed to P31AB-123, P1A61-123, P1A64-123 is not output A P31AB-123, P1A61-123, P1A64-123 is output B - Turn the power switch off.
B → See step 5
A: Go to next step
- CHECK DTC OUTPUT (EV BATTERY) See step 1
B → See step 6
A: Go to next step
- CHECK DTC OUTPUT (EV BATTERY)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / EV Battery / Trouble Codes.
- Read output DTCs.RESULT
Result Proceed to P1A00-123, P1A05-123, P301A-123 is not output A P1A00-123, P1A05-123, P301A-123 is output B - Turn the power switch off.
B → See step 8
A: Go to next step
- REPLACE ELECTRIC VEHICLE BATTERY ASSEMBLY
Refer to COMPONENTS
NEXT → See step 7
- GO TO DTC CHART (P31AB-123). Refer to DTC P31AB-123: EV Battery No. 1 Cell Low Voltage Stack "A"; DTC P1A61-123: EV Battery No. 1 Cell Low Voltage Stack "B"; DTC P1A64-123: EV Battery No. 1 Cell Low Voltage Stack "C"
- GO TO DTC CHART (P0AFC-123). Refer to DTC P0AFC-123: EV Battery No. 1 Pack Sensor Module
- GO TO NO. 1 EV BATTERY - NO. 2 EV BATTERY VOLTAGE DIFFERENCE INSPECTION. Refer to No. 1 EV Battery - No. 2 EV Battery Voltage Difference Inspection
- GO TO DTC CHART (P301A-123). Refer to DTC P301A-123: Open in EV Battery No. 1 Cell Voltage Detection Circuit Stack "A"; DTC P1A00-123: Open in EV Battery No. 1 Cell Voltage Detection Circuit Stack "B"; DTC P1A05-123: Open in EV Battery No. 1 Cell Voltage Detection Circuit Stack "C"