DTC P062F-143: EEPROM Malfunction: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / EV Battery / Trouble Codes.
5. Read the freeze frame data of DTC P062F-143.
   RESULT
   
   

   Result	Proceed to
   "+B" is below 9.5 V	A
   "+B" is 9.5 V or higher	B

6. Turn the power switch off.

B → See step   5 

A: Go to next step 

Refer to ON-VEHICLE INSPECTION - Step 3

NEXT: Go to next step 

NEXT: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the power switch off and wait for 30 seconds or more. [A]
3. Turn the power switch on (IG) and wait for 15 seconds or more. [B]
4. Repeat the steps [A] and [B] 3 times.
5. Turn the Techstream on.
6. Enter the following menus: Powertrain / EV Battery / Trouble Codes.
7. Read output DTCs.
   RESULT
   
   

   Result	Proceed to
   P062F-143 is output.	A
   P062F-143 is not output.	B

8. Turn the power switch off.

B → See step   6 

A: Go to next step 

1. Even though it has been determined that the power management control ECU needs to be replaced, make sure to inspect the voltage difference between No. 1 EV battery and No. 2 EV battery before replacing it.

NEXT → See step   6