Installation [05/2013 - ]

INSTALL COMBINATION METER ASSEMBLY
1. Connect the 2 connectors.
2. Engage the 2 clips.
3. Install the combination meter with 2 screws.
INSTALL INSTRUMENT CLUSTER FINISH NO. 1 PANEL . Refer to INSTALLATION [05/2013 - ] - Step 27
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTE:
When the power to the combination meter is disconnected and reconnected, it will not function normally until 5 minutes elapse or a vehicle speed signal is input.