LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2014 >> FR-S Standard Trans >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge / Display (Diagnostics - Introduction) >> Meter / Gauge System >> Data List / Active Test [07/2013 - 12/2013] >> Data List / Active Test [07/2013 - 12/2013]

Data List / Active Test [07/2013 - 12/2013]

  1. DATA LIST 

    HINT: 

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Combination Meter / Data List.
    5. According to the display on the tester, read the Data List.
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      ODO/TRIP Change SW
      Tail Cancel SW      		 Light control rheostat switch (cancel switch)
      ON or OFF      		 ON: Light control rheostat switch (cancel switch) → TAIL
      OFF: Light control rheostat switch (cancel switch) → OFF      		 -
      ODO/TRIP Change SW ODO/TRIP change switch
      ON or OFF      		 ON: ODO/TRIP switch pushed
      OFF: ODO/TRIP switch not pushed      		 -
      P-Seatbelt Buckle SW Occupant detection sensor (Front passenger side)
      ON or OFF      		 ON: Occupant detection sensor (Front passenger side)→ ON
      OFF: Occupant detection sensor (Front passenger side)→ OFF      		 -
      Vehicle Speed Meter Vehicle speed
      Min.: 0 (0)
      Max.: 255 (158)      		 Approximately same as actual vehicle speed (When vehicle is being driven) Unit: km/h (mph)
      Engine Rpm Engine speed
      Min.: 0
      Max.: 12750      		 Approximately same as actual engine speed (when engine is running) Unit: rpm
      Coolant Temperature Engine coolant temperature
      Min.: 0
      Max.: 127.5      		 After warming up:
      80 to 108 (176 to 226)      		 Unit: °C (°F)
      Multi Display Select Switch Multi Display Select Switch
      ON or OFF      		 ON: DISP switch pushed
      OFF: DISP switch not pushed      		 -
      +B Voltage Value +B voltage
      Min.: 0
      Max.: 25.5      		 Below 1 to 14 Unit: V
      Fuel Input Fuel sender gauge input
      Min.: 0
      Max.: 127.5      		 Fuel sender input value Unit: Liter
      Ambient Temperature Ambient temperature
      Min.: -40 (-40)
      Max.: 87.5 (189.5)      		 Same as outside temperature Unit: °C (°F)
      Rheostat value Light control rheostat switch input
      Min.: 0
      Max.: 100      		 Displays rheostat volume figure
      0 to 100      		 Unit: %
      Quantity of Outside Light Light control rheostat switch output
      Min.: 0
      Max.: 100      		 Displays rheostat volume figure
      0 to 100      		 Unit: %
      Key Remind Sound Key remind sound
      FAST, NORMAL or SLOW      		 Display key reminder buzzer speed setting -
      Tail Remind Buzzer Tail remind buzzer
      ON or OFF      		 ON: Tail remind buzzer ON
      OFF: Tail remind buzzer OFF      		 -
      Driver Side Seatbelt Warning Buzzer Driver seat belt warning buzzer
      ON or OFF      		 ON: Driver side seat belt warning buzzer ON
      OFF: Driver side seat belt warning buzzer OFF      		 -
      P-Seatbelt Warning Buzzer Front passenger seat belt warning buzzer
      ON or OFF      		 ON: Front passenger side seat belt warning buzzer ON
      OFF: Front passenger side seat belt warning buzzer OFF      		 -
      Number of Trouble Code The DTC number which is currently output - -

      HINT: 

      Items for which there are no settings do not appear on the Techstream, or do not operate.

  2. PERFORM ACTIVE TEST 

    HINT: 

    Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
    5. According to the display on the tester, perform the Active Test.
      COMBINATION METER

      Tester Display Test Part Control Range Diagnostic Note
      Speed Meter Operation Speedometer 0, 40, 80, 120, 160, 200, 240 km/h -
      Tachometer Operation Tachometer 0, 1000, 2000, 3000, 4000, 5000, 6000, 7000 rpm -
      Fuel Meter Operation Fuel gauge EMPTY, 1/2, FULL -
      A/T Indicator Operation 1 A/T shift indicator light P, R, N, D, 4, 3, 2, 1
      (Indicator light comes on.)      		 -
      A/T Indicator Operation 2 A/T shift indicator light 5, 6, M
      (Indicator light comes on.)      		 -
      A/T Indicator Operation 3 A/T shift indicator light D
      (Indicator light comes on.)      		 -
      Indicat. Lamp Airbag Airbag warning light OFF/ON
      (Warning light blink.)      		 Vehicle is stopped and engine is idling
      Indicat. Lamp Doors All Open Door warning light OFF/ON
      (Warning light blink.)      		 Vehicle is stopped and engine is idling
      Front Passenger Side Seat Belt Front passenger seat belt warning light OFF/ON
      (Warning light blink.)      		 Vehicle is stopped and engine is idling
      Driver Side Seat Belt Driver side seat belt warning light OFF/ON
      (Warning light blink.)      		 Vehicle is stopped and engine is idling
      Indicat. Lamp ABS ABS warning light OFF/ON
      (Warning light blink.)      		 Vehicle is stopped and engine is idling
      Indicat. Lamp Slip SLIP indicator light OFF/ON
      (Warning light blink.)      		 Vehicle is stopped and engine is idling
      Indicat. Lamp Beam Hi-beam indicator light OFF/ON
      (Indicator light blink.)      		 Vehicle is stopped and engine is idling
      Indicat. Lamp Fr FOG Front fog indicator light OFF/ON
      (Indicator light blink.)      		 Vehicle is stopped and engine is idling
      Indicat. Lamp Rr FOG Rear fog indicator light OFF/ON
      (Indicator light blink.)      		 Vehicle is stopped and engine is idling
      Indicat.Lamp Fuel Low fuel warning light OFF/ON
      (Warning light blink.)      		 Vehicle is stopped and engine is idling
      VSC TRC Indicator TRC OFF/TRAC OFF indicator light OFF/ON
      (Indicator light blink.)      		 Vehicle is stopped and engine is idling
      Indicat. Tire Pressure Warning System TPMS warning light OFF/ON
      (Warning light blink.)      		 Vehicle is stopped and engine is idling
      SPORT Indicator Sport indicator light OFF/ON
      (Indicator light blink.)      		 Vehicle is stopped and engine is idling
      Indicat. Lamp ECT SNOW Snow indicator light OFF/ON
      (Indicator light blink.)      		 Vehicle is stopped and engine is idling
      A/T Oil Temperature Operation A/T oil temperature warning light OFF/ON
      (Warning light blink.)      		 Vehicle is stopped and engine is idling
      Indicat. Lamp Cruise Cruise indicator light (green) OFF/ON
      (Indicator light blink.)      		 Vehicle is stopped and engine is idling
      Indicat. Lamp Brake Brake warning light OFF/ON
      (Warning light blink.)      		 Vehicle is stopped and engine is idling
      Indicat. EPS EPS warning light OFF/ON
      (Warning light blink.)      		 Vehicle is stopped and engine is idling
      Indicat. SET SET indicator light OFF/ON
      (Indicator light blink.)      		 Vehicle is stopped and engine is idling
      Indicat. SIL (Up) Shift up indicator light OFF/ON
      (Indicator light blink.)      		 Vehicle is stopped and engine is idling
      Indicat. SIL (Down) Shift down indicator light OFF/ON
      (Indicator light blink.)      		 Vehicle is stopped and engine is idling
      Indicat. VSC OFF VSC OFF indicator light OFF/ON
      (Indicator light blink.)      		 Vehicle is stopped and engine is idling
      Cruise Warning Cruise warning light (yellow) OFF/ON
      (Warning light blink.)      		 Vehicle is stopped and engine is idling
      Smart System Indicator Smart system indicator light (green) OFF/ON
      (Indicator light blink.)      		 Vehicle is stopped and engine is idling
      Smart System Warning Smart system warning light (yellow) OFF/ON
      (Warning light blink.)      		 Vehicle is stopped and engine is idling
      Check Engine Warning Check engine warning light OFF/ON
      (Warning light blink.)      		 Vehicle is stopped and engine is idling
      Water Temperature Meter Operation Water temperature gauge LOW, NORMAL, HIGH Vehicle is stopped and engine is idling
      Meter Display 1 Drive monitor display 6, 5, 4, 3, 2, 1, 0, All
      (Display light comes on.)      		 Vehicle is stopped and engine is idling
      Meter Display 2 Drive monitor display 9, 8, 7
      (Display light comes on.)      		 Vehicle is stopped and engine is idling

      HINT: 

      • The Techstream shows that the warning lights and indicator lights are illuminated, but those actual lights in the combination meter will blink.
      • Items for which there are no settings do not appear on the Techstream, or do not operate.
      • Telltales for which there are no settings do not operate.
      • When not functioning normally, there may be a combination meter assembly malfunction.
scientia non olet · About LEMON Manuals