On-Vehicle Inspection [07/2013 - ]
WARNING:
Be sure to correctly follow the removal and installation procedures for the rear floor side airbag sensor.
- CHECK NO. 2 AIRBAG SENSOR ASSEMBLY (for Vehicle not Involved in Collision)
- Perform a diagnostic system check. Refer to DTC CHECK / CLEAR [07/2013 - ] .
- CHECK NO. 2 AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)
- Perform a diagnostic system check. Refer to DTC CHECK / CLEAR [07/2013 - ] .
- Visually check for defects with the No. 2 airbag sensor assembly installed on the vehicle.
HINT:
The defects are as follows:
- Cracks on the sensor housing
- Dents on the sensor housing
- Chips on the sensor housing
- Cracks or other damage to the connector
- Damage to the serial number
OK
No defects are found.
If any of the defects is found, replace the No. 2 airbag sensor assembly with a new one.
- CHECK NO. 2 AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag is Deployed)
- When front seat airbags or curtain shield airbags have deployed as the result of a collision, be sure to replace No. 2 airbag sensor assembly.
- Visually check the No. 2 airbag sensor assembly in undamaged areas for defects.
HINT:
The defects are as follows:
- Cracks on the sensor housing
- Dents on the sensor housing
- Chips on the sensor housing
- Cracks or other damage to the connector
- Damage to the serial number
OK
No defects are found.
If any of the defects is found, replace the No. 2 airbag sensor assembly with a new one.