On-Vehicle Inspection [07/2013 - ]

WARNING:

Be sure to correctly follow the removal and installation procedures for the curtain shield airbag assemblies.

INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (for Vehicle not Involved in Collision)
1. Perform a diagnostic system check. Refer to DTC CHECK / CLEAR [07/2013 - ] .
2. Visually check for defects with the curtain shield airbag assemblies installed on the vehicle.
  HINT:
  
  The defects are as follows:
  - Cuts on each pillar garnish or the roof headlining assembly around the curtain shield airbag assemblies
  - Small cracks on each pillar garnish or the roof headlining assembly around the curtain shield airbag assemblies
  - Significant discoloration on each pillar garnish or the roof headlining assembly around the curtain shield airbag assemblies
  OK
  
  No defects are found.
  
  If any of the defects is found, replace each pillar garnish or the roof headlining assembly with a new one.
INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)
1. Perform a diagnostic system check. Refer to DTC CHECK / CLEAR [07/2013 - ] .
2. Visually check for defects with the curtain shield airbag assemblies removed from the vehicle.
  HINT:
  
  The defects are as follows:
  - Cuts
  - Small cracks
  - Significant discoloration
  - Cracks or other damage to the connector
  OK
  
  No defects are found.
  
  If any of the defects is found, replace the curtain shield airbag assembly with a new one.