DTC B11F1: Front Airbag Inflated: Procedure

REPLACE CORRESPONDING PARTS
1. Replace the following parts.
  HINT:
  
  If the DTC B11F1 is stored, it cannot be cleared until the following parts are replaced.
  - Airbag ECU assembly. Refer to REMOVAL [07/2013 - 12/2013]
  - Horn button assembly (Driver side squib). Refer to REMOVAL [07/2013 - ]
  - Instrument panel passenger airbag assembly (Front passenger side squib). Refer to REMOVAL [07/2013 - ]
  - Front seat outer belt assembly RH (Front pretensioner squib RH). Refer to REMOVAL [07/2013 - ]
  - Front seat outer belt assembly LH (Front pretensioner squib LH). Refer to REMOVAL [07/2013 - ]
  - Front airbag sensor RH. Refer to REMOVAL [07/2013 - ]
  - Front airbag sensor LH. Refer to REMOVAL [07/2013 - ]
  - Spiral cable sub-assembly. Refer to REMOVAL [07/2013 - 12/2013]
NEXT → END