Speedometer Malfunction: Procedure

1. Check if CAN communication DTCs are output. Refer to DIAGNOSIS SYSTEM [07/2013 - 12/2013] .
   RESULT
   
   

   Result	Proceed to
   DTCs are not output.	A
   DTCs are output.	B

B → See step   8 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
5. According to the display on the tester, perform the Active Test.
   COMBINATION METER
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Speed Meter Operation	Speedometer	0, 40, 80, 120, 160, 200, 240 km/h	-

   OK

   The vehicle speed displayed on the tester is approximately the same as that of the speedometer reading.

NG → See step   7 

OK: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Data List.
5. According to the display on the tester, read the Data List.
   COMBINATION METER
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Vehicle Speed Meter	Vehicle speed / Min.: 0 (0) Max.: 255 (158)	Approximately same as actual vehicle speed (when vehicle is being driven)	Unit km/h (mph)

   OK

   The vehicle speed displayed on the tester is approximately the same as the actual vehicle speed.

   NOTE:

   Determine whether the value displayed on the tester is within the acceptable range by referring to the reference values described in "On-Vehicle Inspection". Refer to ON-VEHICLE INSPECTION [07/2013 - 12/2013] .

NG → See step   7 

OK: Go to next step 

1. Check if the vehicle stability control system outputs DTCs. Refer to DTC CHECK / CLEAR [07/2013 - ] .
   RESULT
   
   

   Result	Proceed to
   DTCs are not output.	A
   DTCs are output.	B

B → See step   9 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.
5. According to the display on the tester, read the Data List.
   COMBINATION METER
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Vehicle Speed	Vehicle speed / Min.: 0 (0) Max.: 326.4 (202.8)	Approximately same as actual vehicle speed (when vehicle is being driven)	Unit km/h (mph)

   OK

   The vehicle speed displayed on the tester is approximately the same as the actual vehicle speed.

   NOTE:

   Determine whether the value displayed on the tester is within the acceptable range by referring to the reference values described in "On-Vehicle Inspection". Refer to ON-VEHICLE INSPECTION [07/2013 - 12/2013] .

NG → See step   9 

OK: Go to next step 

1. Replace the combination meter assembly with a new one. Refer to REMOVAL [07/2013 - ] .

   OK

   The operation of the speedometer returns to normal.

NG → See step   10 

OK → END