Removal [07/2013 - ]

REMOVE CENTER EXHAUST PIPE ASSEMBLY
Refer to REMOVAL [07/2013 - ]
REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
1. Place matchmarks on the differential companion flange and flexible coupling.
  
  Fig 1: Identifying Matchmarks On Differential Companion Flange & Flexible Coupling
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  TEXT IN ILLUSTRATION
  
  *a Matchmark
2. Remove the 4 nuts, 4 bolts and 4 washers.
3. Remove the 2 bolts.
  
  Fig 2: Locating Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Disconnect the center support bearing.
5. Remove the front propeller shaft with the center bearing assembly.
6. Insert SST in the transmission to prevent oil leaks. (for Manual Transmission)
  
  Fig 3: Inserting SST In Transmission (For Manual Transmission)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE:
  Be careful not to damage the oil seal.
  - SST: 09325-20010
7. Insert SST in the transmission to prevent oil leaks. (for Automatic Transmission)
  
  Fig 4: Inserting SST In Transmission (For Automatic Transmission)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE:
  Be careful not to damage the oil seal.
  - SST: 09325-40010