Driver Side Seat Belt Warning Light does not Operate: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
5. Perform the Active Test according to the display on the Techstream.

   OK

   Driver side seat belt warning light condition can be switched by Active Test.

   COMBINATION METER
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Driver Side Seat Belt	Driver side seat belt warning light	ON/OFF	-

NG → See step   5 

OK: Go to next step 

1. Remove the front seat inner belt assembly LH. Refer to REMOVAL [07/2013 - ] .
2. Inspect the front seat inner belt assembly LH. Refer to INSPECTION [07/2013 - ] .

NG → See step   4 

OK: Go to next step 

1. Disconnect the H19 front seat inner belt assembly LH connector.
2. Disconnect the D7 combination meter assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   D7-37 (DBKL) - H19-1	Always	Below 1 Ω
   H19-1 - Body ground	Always	10 kΩ or higher
   H19-2 - Body ground	Always	Below 1 Ω

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   5