Speedometer Malfunction: Procedure

1. Check if a CAN communication DTC is output. Refer to DIAGNOSIS SYSTEM .
   RESULT
   
   

   Result	Proceed to
   CAN communication DTC is not output	A
   CAN communication DTC is output	B

B → See step   5 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
5. According to the display on the Techstream, perform the Active Test.
   COMBINATION METER
   
   

   Techstream Display	Test Part	Control Range	Diagnostic Note
   Speed Meter Operation	Speedometer	0, 40, 80 mph	Vehicle is stopped and power switch on (IG)

   OK

   Speedometer indication is normal.

NG → See step   6 

OK: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Data List.
5. According to the display on the Techstream, read the Data List.
   COMBINATION METER
   
   

   Techstream Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Vehicle Speed Meter	Vehicle speed/ Min.: 0, Max.: 255	Approximately same as actual vehicle speed (When vehicle is being driven)	-

   OK

   Vehicle speed displayed on the Techstream is almost the same as the speedometer indication.

NG → See step   6 

OK: Go to next step 

1. Check if a electronically controlled brake DTC is output. Refer to DTC CHECK / CLEAR .
   RESULT
   
   

   Result	Proceed to
   Electronically controlled brake DTC is not output	A
   Electronically controlled brake DTC is output	B

B → See step   7 

A → See step   6