Typical Enabling Conditions
| Monitor runs whenever following DTCs not stored | P0030, P0031, P0032 (Air fuel ratio sensor - heater) P0068, P0107, P0108 (Manifold absolute pressure (MAP) sensor) P0117, P0118, P0125 (Engine coolant temperature (ECT) sensor) P0122, P0123, P0222, P0223 (Throttle position sensor) P0131, P0132 (Air fuel ratio sensor - ECM input voltage) P0134, P2195, P2196 (Air fuel ratio sensor - output voltage) P0300, P0301, P0302, P0303, P0304 (Misfire) P0461, P0462, P0463 (Fuel level sensor (FL)) P0500 (Vehicle speed sensor (VSS)) P0604 (RAM in ECM) P0605 (ROM in ECM) P0606 (Control Module Processor) P0851, P0852 (Neutral position switch) P1160 (Throttle return spring) P2101, P2102 (Throttle actuator control motor) P2109 (Throttle position sensor minimum stop) P2119 (Throttle actuator control) P2122, P2123, P2127, P2128 (Accelerator pedal position sensor (APPS) circuit) P2135 (Throttle position sensor (TPS) correlation) P2138 (Accelerator pedal position sensor (APPS) correlation) |
| Fuel level | 15% or more |
| Atmospheric pressure | 75.06 kPa [563 mmHg] or more |
| Battery voltage | 10.9 V or more |
| Engine coolant temperature | 60°C (140°F) or higher |
| Elapsed time after engine start | 10.49 seconds or more |
| Closed control in ISC | Active |
| Lambda | 0.81 to 1.1 |
| Elapsed time after A/C switch OFF ←→ ON | More than 5.1 seconds |
| Elapsed time after changing intake manifold pressure =< 4 kPa (30 mmHg) | More than 5.1 seconds |
| Vehicle speed | 0 km/h (0 mph) |
| Elapsed time after neutral switch OFF ←→ ON | More than 5.1 seconds |