Monitor Description
While the engine is being cranked, battery voltage is applied to terminal STA of the ECM. If the ECM detects the starter control (STA) signal after the engine is started, it determines that there is a malfunction in the STA circuit. The ECM then illuminates the MIL and stores the DTC.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0512 | Starter signal remains input for 30 seconds or more after engine started. (1 trip detection logic) |
|
| P0616 | No starter signal is input when engine started. (1 trip detection logic) |
|
| P0617 | Starter signal remains input after engine started. (1 trip detection logic) |
|
| P081A | Short in ST CUT relay circuit is detected. (1 trip detection logic) |
|