Continuity And Resistance Check

Disconnect the battery terminal or wire so there is no voltage between the check points.
Contact the two leads of an ohmmeter to each of the check points.

Fig 1: Performing Continuity And Resistance Check
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

If the circuit has diodes, reverse the two leads and check again.

When contacting the negative lead to the diode positive side and the positive lead to the negative side, there should be continuity.

When contacting the two leads in reverse, there should be no continuity.

Fig 2: Performing Continuity And Resistance Check (With Leads Reversed)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Use a volt/ohmmeter with high impedance (10kΩ/V minimum) for troubleshooting of the electrical circuit.

Fig 3: Troubleshooting Electrical Circuit Using Volt/Ohmmeter With High Impedance
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002