Tachometer Malfunction: Procedure

1. Check if CAN communication DTCs are output. Refer to DTC CHECK / CLEAR [03/2012 - ] .
   RESULT
   
   

   Result	Proceed to
   DTCs are not output	A
   DTCs are output	B

B → See step   7 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
5. According to the display on the tester, perform the Active Test.
   COMBINATION METER
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Tachometer Operation	Tachometer	0, 1000, 2000, 3000,, 4000, 5000, 6000, 7000 rpm	-

   OK

   The engine speed displayed on the tester is approximately the same as that of the tachometer reading.

NG → See step   10 

OK: Go to next step 

1. Connect the Techstream to the DLC3.
2. Start the engine.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Data List.
5. According to the display on the tester, read the Data List.
   COMBINATION METER
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Engine Rpm	Engine speed Min.: 0 Max.: 12750	Approximately same as actual engine speed (when engine is running)	Unit: rpm

   OK

   The engine speed displayed on the tester is approximately the same as that displayed on the combination meter assembly.

   NOTE:

   Determine whether the value displayed on the tester is within the acceptable range by referring to the reference values described in "On-Vehicle Inspection". Refer to ON-VEHICLE INSPECTION [03/2012 - 05/2013] .

NG → See step   10 

OK: Go to next step 

1. Check if the SFI system outputs DTCs. Refer to DTC CHECK / CLEAR [03/2012 - ] .
   RESULT
   
   

   Result	Proceed to
   DTCs are not output	A
   DTCs are output	B

B → See step   8 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Start the engine.
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine / Data List.
5. According to the display on the tester, read the Data List.
   COMBINATION METER
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Engine Speed	Engine speed Min.: 0 Max.: 16383.75	Approximately same as actual engine speed (when engine is running)	Unit: rpm

   OK

   The engine speed displayed on the tester is approximately the same as that displayed on the combination meter assembly.

   NOTE:

   Determine whether the value displayed on the tester is within the acceptable range by referring to the reference values described in "On-Vehicle Inspection". Refer to ON-VEHICLE INSPECTION [03/2012 - 05/2013] .

NG → See step   8 

OK: Go to next step 

1. Replace the combination meter assembly with a new one. Refer to REMOVAL [03/2012 - ] .

   OK

   The operation of the tachometer returns to normal.

NG → See step   9 

OK → END