Inspection [03/2012 - ]
- INSPECT MAP LIGHT ASSEMBLY
- Check the map light assembly operation.
- Apply battery voltage to the terminals and check that the light comes on.OK:
Condition Switch Condition Specified Condition Battery positive (+) - 2 (+B)
Battery negative (-) - 1 (GND)Map light switch ON Map light comes on Battery positive (+) - 2 (+B)
Battery negative (-) - 3 (DOOR SW)Map light switch DOOR Map light comes on If the result is not specified, replace the map light bulb or map light assembly.
TEXT IN ILLUSTRATION*a Component without harness connected
(Map Light Assembly)
- Apply battery voltage to the terminals and check that the light comes on.
- Check the map light assembly operation.