Data List / Active Test [05/2013 - ]
- DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuator and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTE:In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Main Body / Data List.
- Read the Data List according to the display on the Techstream.MAIN BODY
Tester Display Measurement Item/Range Normal Condition Diagnostic Note DRL Function DRL function / ON or OFF Customize setting displayed - Light Auto OFF Delay Light auto OFF delay / Off, 30 s, 60 s or 90 s Customize setting displayed - D Door Courtesy SW Driver side door courtesy light switch signal / ON or OFF ON: Driver side door open
OFF: Driver side door closed- IG SW Ignition switch ON signal / ON or OFF ON: Ignition switch ON
OFF: Ignition switch off- ACC SW Ignition switch ACC signal / ON or OFF ON: Ignition switch ACC
OFF: Ignition switch off- Dimmer SW Dimmer switch high position signal / ON or OFF ON: Dimmer switch in high or high flash position
OFF: Dimmer switch in low position- Passing Light SW Dimmer switch high flash position (pass) signal / ON or OFF ON: Dimmer switch in high flash position
OFF: Dimmer switch not in high flash position- Front Fog Light SW Front fog light switch signal / ON or OFF ON: Front fog light switch on
OFF: Front fog light switch off- Auto Light SW* Light control switch AUTO position signal / ON or OFF ON: Light control switch in AUTO position
OFF: Light control switch not in AUTO position- Head Light SW (Head) Light control switch head position signal / ON or OFF ON: Light control switch in HEAD position
OFF: Light control switch not in HEAD position- Head Light SW (Tail) Light control switch tail position signal / ON or OFF ON: Light control switch in TAIL or HEAD position
OFF: Light control switch in neither TAIL nor HEAD position- Illumination Rate Info* Illumination rate information / 0.00 ms. to 2162.65 ms. Value is output according to ambient light levels - Sensitivity* Sensitivity of the automatic light control system / Light2, Light1, Normal, Dark1 or Dark2 Customize setting displayed - Rear Fog Lamp Monitor Rear fog light output / ON or OFF ON: Rear fog light on
OFF: Rear fog light off- Lighting 1 Light control switch tail position signal / ON or OFF ON: Light control switch in TAIL or HEAD position
OFF: Light control switch in neither TAIL nor HEAD position- Lighting 2 Light control switch head position signal / ON or OFF ON: Light control switch in HEAD position
OFF: Light control switch not in HEAD position- Lighting Hi Light control switch head (Hi) position signal / ON or OFF ON: Headlight high beam on
OFF: Headlight high beam off- Front Fog Light Output Front fog light output / ON or OFF ON: Front fog light on
OFF: Front fog light off- DRL Output DRL output / ON or OFF ON: DRL output
OFF: Normal- - *: w/ Automatic Light Control System
HINT:
Items for which there are no settings do not appear on the Techstream, or do not operate.
- ACTIVE TEST
HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Main Body / Active Test.
- Perform the Active Test according to the display on the Techstream.MAIN BODY
Tester Display Test Part Control Range Diagnostic Note Daytime Running Light Daytime running lights ON/OFF - Taillight Relay Taillight relay ON/OFF - Headlight Relay Headlight relay ON/OFF - Headlight Hi Headlight (high beam headlights) ON/OFF - Front Fog Light Relay Front fog light relay ON/OFF - HINT:
Items for which there are no settings do not appear on the Techstream, or do not operate.