DTC Check / Clear

CHECK DTC
1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / (desired system) / Trouble Codes.
5. Check for DTCs and then write them down.
  HINT:
  
  Refer to the Techstream operator's manual for further details.
6. Confirm the details of the DTCs. Refer to DIAGNOSTIC TROUBLE CODE CHART .
CLEAR DTC
1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / (desired system) / Trouble Codes.
  HINT:
  
  Refer to the Techstream operator's manual for further details.
5. Clear DTCs.
  HINT:
  
  Refer to the Techstream operator's manual for further details.