Speedometer Malfunction: Procedure

1. Check DTC. Refer to DTC CHECK / CLEAR .

   Result

   Result	Proceed to
   DTC U0129 is not output	A
   DTC U0129 is output	B

B → See step   9 

A: Go to next step 

1. Check DTCs. Refer to DTC CHECK / CLEAR .

   Result

   Result	Proceed to
   DTC C0200/31, C0205/32, C0210/33 and/or C0215/34 is not output	A
   DTC C0200/31, C0205/32, C0210/33 and/or C0215/34 is output	B

B → See step   8 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch on (IG) and turn the tester on.
3. Operate the Techstream according to the display and select "Active Test". Refer to DATA LIST / ACTIVE TEST .

   Body Electrical / Combination Meter / Active Test

   Tester Display	Teat Part	Control Range	Diagnostic Note
   Speed Meter Operation	Speedometer	0/40/80/120 mph	Vehicle is stopped and ignition switch ON
   		0/40/80/12/160/200 km/h

   OK

   Vehicle speed displayed on the tester is approximately the same as that of the speedometer reading.

NG → See step   7 

OK: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch on (IG) and the tester on.
3. Operate the Techstream according to the display and select "Data List". Refer to DATA LIST / ACTIVE TEST .

   Body Electrical / Combination Meter / Data List

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Vehicle Speed Meter	Vehicle speed/ Min.: 0 (0), Max.: 255 (158)	Approximately same as actual vehicle speed (When vehicle is being driven)	Unit: km/h (mph)

   OK

   Vehicle speed displayed on the tester is approximately the same as the actual vehicle speed

   NOTE:

   Determine whether the value displayed on the tester is within the acceptable range by referring to reference values described in "ON-VEHICLE INSPECTION" See step  1.

NG → See step   5 

OK → See step   6 

1. Replace the combination meter assembly with a new or a normal one. Refer to REMOVAL .

   OK

   The operation of the speedometer returns to normal.

NG → See step   10 

OK → END