Front Passenger Side Seat Belt Warning Light Malfunction: Procedure

1. for Airbag System:
   1. Clear the DTCs. Refer to DTC CHECK / CLEAR .
   2. Check for DTCs. Refer to DTC CHECK / CLEAR .
2. for Occupant Classification System:
   1. Clear the DTCs. Refer to DTC CHECK / CLEAR .
   2. Check for DTCs. Refer to DTC CHECK / CLEAR .
   RESULT
   
   

   Result	Proceed to
   DTC is not output	A
   Airbag system DTC is output	B
   Occupant classification system DTC is output	C

B → See step   7 

C → See step   5 

A: Go to next step 

1. Operate the Techstream according to the display and select Active Test. Refer to DATA LIST / ACTIVE TEST .
   COMBINATION METER
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Front Passenger Side Seat Belt	Front passenger side seat belt warning light	ON/OFF	Confirm that the vehicle is stopped and the engine is idling.

   OK

   Front passenger side seat belt warning light condition can be switched by Active Test.

NG → See step   6 

OK: Go to next step 

1. Temporarily replace the center airbag sensor with a new one. Refer to REMOVAL .

NEXT: Go to next step 

1. Check the front passenger side seat belt warning light function.

   OK

   Front passenger side seat belt warning light operates normally.

NG → See step   6 

OK → END (CENTER AIRBAG SENSOR IS DEFECTIVE)