LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2012 >> tC Automatic Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting System (Interior) (Service Information) >> ROOM LIGHT (w/o Sliding Roof) >> Inspection >> Inspection

ROOM LIGHT (w/o Sliding Roof): Inspection: Inspection

  1. INSPECT MAP LIGHT ASSEMBLY 
    1. Measure the resistance according to the value(s) in the table below.
      Fig 1: Inspecting Map Light Assembly
      GTY314128Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance

      Tester Connection Switch Condition Specified Condition
      1 (B) - 4 (E) Not Dome position 10 kΩ or higher
      On position Below 1 Ω
      1 (B) - 3 (CTY) Not door position 10 kΩ or higher
      On position Below 1 Ω
      1 (B) - 4 (E) OFF 10 kΩ or higher
      Spot switch on (for LH side) Below 1 Ω
      Spot switch on (for RH side) Below 1 Ω
      TEXT IN ILLUSTRATION

      *a Component without harness connected
      (Map Light Assembly)

      If the result is not as specified, replace the Map Light Assembly.

scientia non olet · About LEMON Manuals