Combination Meter: Removal: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE INSTRUMENT CLUSTER FINISH PANEL

Fig 1: Identifying Cluster Finish Panel Claws And Clips
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Disengage the 8 claws and 5 clips and remove the cluster finish panel.
REMOVE COMBINATION METER ASSEMBLY

Fig 2: Identifying Combination Meter Assembly Clips
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Disconnect the 2 connectors and remove the 2 screws.
2. Disengage the 2 clips and remove the combination meter assembly.