Driver Side Seat Belt Warning Light does not Operate: Procedure

1. Remove the front seat inner belt.
   Fig 1: Identifying Front Seat Inner Belt Terminals (Driver Side)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance of the belt.

   Standard resistance

   Tester Connection	Condition	Specified Condition
   1 - 2	Seat belt is fastened	1 MΩ or higher
   1 - 2	Seat belt is not fastened	Below 1 Ω

NG → REPLACE FRONT SEAT INNER BELT ASSEMBLY (DRIVER SIDE) 

OK: Go to next step 

1. Disconnect the F7 belt connector.
   Fig 2: Identifying Front Seat Inner Belt And Combination Meter Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the C6 meter connector.
3. Measure the resistance of the wire harness side connectors.

   Standard resistance

   Tester Connection	Specified Condition
   F7-1 - Body ground	Below 1 Ω
   F7-2 - C6-5	Below 1 Ω
   F7-2 - Body ground	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS AND CONNECTOR 

OK → REPAIR OR REPLACE COMBINATION METER ASSEMBLY