REAR SEAT ASSEMBLY (for LH Side): Installation

NOTE: Always use "TORX" socket wrench E10 when installing the rear seat.

INSTALL REAR SEAT ASSEMBLY
1. Insert the 2 location pins through the 2 body holes and install the rear seat.
2. Using "TORX" socket wrench E10, install the 4 bolts in the sequence shown in the illustration.
  Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf)
  
  Fig 1: Identifying Rear Seat Assembly Bolt Installing Sequence
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the rear seat cushion.
4. Using "TORX" socket wrench E10, install the 3 bolts in the sequence shown in the illustration.
  Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf)
  
  Fig 2: Identifying Rear Seat Cushion Bolt Installing Sequence
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 2 REAR SEAT LEG COVER
1. Engage the 3 claws and install the No. 2 rear seat leg cover.
  
  Fig 3: Identifying No. 2 Rear Seat Leg Cover Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 REAR SEAT LEG COVER
1. Engage the 4 claws and install the No. 1 rear seat leg cover.
  
  Fig 4: Identifying No. 1 Rear Seat Leg Cover Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002