LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2009 >> xD Standard >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper & Washer >> Front Wiper Motor >> Removal

Front Wiper Motor: Removal

  1. REMOVE FRONT WIPER ARM HEAD CAP 
    1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the 2 front wiper arm caps.
      Fig 1: Identifying Claws And Front Wiper Arm Caps
      G05402603Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH 
    1. Operate the wiper, then stop the wiper motor in the automatic stop position.
    2. Remove the nut and front wiper arm and blade assembly LH.
    3. Fig 2: Locating Nut And Front Wiper Arm
      G05402604Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH 

    HINT:

    Use the same procedure as for the LH side.

  4. REMOVE HOOD TO COWL TOP SEAL 
    1. Disengage the 7 clips and remove the hood to cowl top seal.
      Fig 3: Identifying Clips And Hood To Cowl Top Seal
      G05402605Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY 
    1. Remove the clip.
    2. Disengage the 4 claws and 4 guides and remove the cowl top ventilator louver RH.
      Fig 4: Identifying Claws And Guides On Cowl Top Ventilator Louver RH
      G05402606Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE COWL TOP VENTILATOR LOUVER LH 
    1. Remove the clip.
    2. Disengage the 5 claws and 5 guides and remove the cowl top ventilator louver LH.
      Fig 5: Identifying Claws And Guides On Cowl Top Ventilator Louver LH
      G05402607Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE FRONT WIPER MOTOR AND LINK 
    1. Disengage the clamp.
    2. Remove the 2 bolts.
    3. Fig 6: Locating Bolts
      G05402608Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Slide the front wiper motor and link. Disengage the link from the rubber pin, then disconnect the connector and remove the front wiper motor and link
  8. REMOVE FRONT WIPER MOTOR 
    1. Using a screwdriver with its tip wrapped in protective tape, disconnect the rod of the wiper link assembly from the crank arm pivot of the front wiper motor as shown in the illustration.
      Fig 7: Prying Rod Of Wiper Link Assembly
      G05402609Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Put matchmarks on the crank arm and front wiper motor, as shown in the illustration.
    3. Fig 8: Identifying Matchmarks
      G05402610Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the nut and remove the crank arm.
    5. Remove the 3 bolts and remove the front wiper motor.
      Fig 9: Locating Front Wiper Motor Bolts
      G05402611Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002