Differential Oil Seal: Removal

WARNING: This page is about a different variant/trim than selected.

DRAIN TRANSAXLE OIL
1. Remove the filler plug and the gasket.
2. Remove the drain plug and gasket, and then drain the manual transaxle oil.
3. Install a new gasket and the drain plug.
  Torque: 39 N*m (400 kgf*cm, 29 ft.*lbf)
REMOVE FRONT WHEELS
REMOVE FRONT AXLE HUB NUT LH (See REMOVAL )
REMOVE FRONT AXLE HUB NUT RH
HINT:

The removal procedure for the RH side is the same as that for the LH side.
SEPARATE FRONT SPEED SENSOR LH (See REMOVAL )
SEPARATE FRONT SPEED SENSOR RH
HINT:

The separation procedure for the RH side is the same as that for the LH side.
SEPARATE FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH (See REMOVAL )
SEPARATE FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY RH
HINT:

The separation procedure for the RH side is the same as that for the LH side.
SEPARATE TIE ROD END SUB-ASSEMBLY LH (See REMOVAL )
SEPARATE TIE ROD END SUB-ASSEMBLY RH
HINT:

The separation procedure for the RH side is the same as that for the LH side.
SEPARATE FRONT STABILIZER LINK ASSEMBLY LH (See REMOVAL )
SEPARATE FRONT STABILIZER LINK ASSEMBLY RH
HINT:

The separation procedure for the RH side is the same as that for the LH side.
SEPARATE FRONT AXLE ASSEMBLY LH (See REMOVAL )
SEPARATE FRONT AXLE ASSEMBLY RH
HINT:

The separation procedure for the RH side is the same as that for the LH side.
REMOVE FRONT DRIVE SHAFT ASSEMBLY LH (See DISASSEMBLY )
REMOVE FRONT DRIVE SHAFT ASSEMBLY RH (See DISASSEMBLY )
REMOVE TRANSAXLE CASE OIL SEAL
1. Using SST, remove the oil seal.
  SST 09308-00010
  
  Fig 1: Removing Oil Seal With SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE TRANSMISSION CASE OIL SEAL
1. Using SST, remove the oil seal.
  SST 09308-00010
  
  Fig 2: Removing Oil Seal With SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002