LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2009 >> xB Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter >> Meter / Gauge System >> Data List / Active Test

Data List / Active Test

  1. READ DATA LIST 

    HINT:

    Using the tester's "DATA LIST" allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the "DATA LIST" early in troubleshooting is one way to save time.

    1. Connect Techstream to the DLC3.
    2. Turn the ignition switch on (IG) and turn the tester ON.
    3. Select the following menu items: Body Electrical / (desired system) / Data List.
    4. Check the results by referring to the table below.
      DATA LIST - COMBINATION METER REFERENCE

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Tail Relay SW Taillight relay
      ON or OFF      		 ON Headlight dimmer switch (Light control switch) → TAIL
      OFF Headlight dimmer switch (Light control switch) → OFF      		 -
      Tail Cancel SW Tail cancel switch
      ON or OFF      		 ON Headlight dimmer switch (Light control switch) → TAIL or HEAD
      OFF Headlight dimmer switch (Light control switch) → OFF      		 -
      ODO/TRIP Change SW ODO/TRIP switch
      ON or OFF      		 ON ODO/TIRP switch pushed
      OFF ODO/TIRP switch not pushed      		 -
      P-Seatbelt Buckle SW Front passenger belt buckle switch
      ON or OFF      		 ON Front passenger seat belt is fastened
      OFF Front passenger seat belt is unfastened      		 -
      Vehicle Speed Meter Vehicle speed
      Min 0 (0)
      Max 158(255)      		 Approximately same as vehicle speed (When vehicle is driving) Unit mph (km/h)
      Engine RPM Engine speed
      Min 0
      Max 12,750      		 Approximately same as actual engine speed Unit rpm
      Coolant Temperature Engine coolant temperature
      Min 0
      Max 127 5 (2615)      		 After warming up, 75 to 105 (167 to 221) Unit °C (°F)
      Multi Display Select Switch Multi display select switch
      ON or OFF      		 ON Multi display select switch pushed
      OFF Multi display select switch not pushed      		 -
      +B Voltage Value Battery voltage
      Min 0
      Max 25 5      		 Between 1 V and 14 V Unit V
      Fuel Input Fuel sender gauge input
      Min 0 (0)
      Max 127 5 (134 7, 112 2)      		 Fuel sender input value Unit Liters (US qts, lmp, qts)
      Ambient Temperature Ambient Temperature
      Min -40 (-40)
      Max 87 5 (189 5)      		 Same as outside temperature Unit °C (°F)
      Rheostat value Rheostat value
      Min 0
      Max 100      		 Light control rheostat switch is dark → bright Unit %
      Communication ECM/METER DTC 1 ECM communication stop history
      Rec or Unrec      		 Displays DTC history -
      ECM ODO (History 1) ECM odometer history
      Min 0
      Max 999999      		 With history 0 to 999999
      Without history FFFFFFh      		 -
      Communication ECM/METER DTC 2 ECM communication stop history
      Rec or Unrec      		 Displays DTC history -
      ECM ODO (History 2) ECM odometer history
      Min 0
      Max 999999      		 With history 0 to 999999
      Without history FFFFFFh      		 -
      Communication ECM/METER DTC 3 ECM communication stop history
      Rec or Unrec      		 Displays DTC history -
      ECM ODO (History 3) ECM odometer history
      Min. 0
      Max 999999      		 With history 0 to 999999
      Without history FFFFFFh      		 -
      Communication ABS/METER DTC 1 Skid control ECU communication stop history
      Rec or Unrec      		 Displays DTC history -
      ECM ODO (History 1) Skid control ECU odometer history
      Min 0
      Max 999999      		 With history 0 to 999999
      Without history FFFFFFh      		 -
      Communication ABS/METER DTC 2 Skid control ECU communication stop history
      Rec or Unrec      		 Displays DTC history -
      ECM ODO (History 2) Skid control ECU odometer history
      Min 0
      Max. 999999      		 With history 0 to 999999
      Without history FFFFFFh      		 -
      Communication ABS/METER DTC 3 Skid control ECU communication stop history
      Rec or Unrec      		 Displays DTC history -
      ECM ODO (History 3) Skid control ECU odometer history
      Min 0
      Max 999999      		 With history .0 to 999999
      Without history FFFFFFh      		 -
      Key Remind Sound Key remind sound
      FAST, NORMAL or SLOW      		 Display key reminder buzzer speed setting -
      D-Seatbelt Warning Buzzer Front driver seat belt warning buzzer
      ON or OFF ON.      		 Front driver side seat belt warning buzzer ON setting OFF Front driver side seat belt warning buzzer OFF setting -
      P-Seatbelt Warning Buzzer Front passenger seat belt warning buzzer
      ON or OFF      		 ON Front passenger side seat belt warning buzzer ON setting OFF Front passenger side seat belt warning buzzer OFF setting -
      Number of Trouble Code The number of the DTC which is currently output - -

      Main Body ECU 

      DATA LIST - MAIN BODY ECU REFERENCE

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      D Door Courtesy SW Driver side door courtesy light switch signal
      ON or OFF      		 ON Driver side door is open
      OFF. Driver side door is closed      		 -
      Key Unlock Warning SW Unlock warning switch signal
      ON or OFF      		 ON Key is in ignition key cylinder
      OFF No key is in ignition key cylinder      		 -
  2. PERFORM ACTIVE TEST 

    HINT:

    Performing the tester's "ACTIVE TEST" allows relay, VSV, actuator and other items to be operated without removing any parts.

    Performing the "ACTIVE TEST" early in troubleshooting is one way to save time.

    The "DATA LIST" can be displayed during the "ACTIVE TEST".

    1. Connect Techstream to the DLC3.
    2. Turn the ignition switch on (IG) and turn the tester ON.
    3. Select the following menu items: Body Electrical / Combination Meter / Active Test.
    4. Perform the "ACTIVE TEST" by referring to the table below.
      ACTIVE TEST - COMBINATION METER REFERENCE

      Tester Display Test Part Control Range
      Speed Meter Operation 0 / 24 (40) /48 (80) /72 (120) / 96 (160) /120 (200) mph (km/h) Value selected during Active Test is displayed
      Tachometer Operation 0 / 1,000 / 2,000 / 3,000 / 4,000 / 5,000 / 6,000 / 7,000 rpm Value selected during Active Test is displayed
      Fuel Meter Operation EMPTY/1/2/FULL Value selected during Active Test is displayed
      Water Temperature Meter Operation LOW/NORMAL/HIGH Value selected during Active Test is displayed
      A/T Indicator Operation 1 *1 P / R / N / D / 4 (M/S) / 3 (M/S) / 2 / L Position selected during Active Test illuminates
      A/T Indicator Operation 2 *1 5/6/7/Es/M/S/B Position selected during Active Test illuminates
      Meter Display 1 ALL / 0 /1 / 2 / 3 / 4 / 5 / 6 -
      Meter Display 2 7/8/9 -
      Indicate Lamp Airbag AIR BAG warning light ON/OFF -
      Indicate Lamp Doors All Open DOOR warning light ON/OFF -
      Indicate Lamp P-seat Belt P-BELT warning light ON/OFF -
      Indicate Lamp D-seat Belt D-BELT warning light ON/OFF -
      Indicate Lamp ABS ABS warning light ON/OFF -
      Indicate Lamp Charge CHARGE indicator light ON/OFF -
      Indicate Lamp Slip *2 SLIP warning light ON/OFF -
      Indicate Lamp Fuel FUEL warning light ON/OFF -
      Indicate Tire Pressure Warning *3 TIRE PRESSURE warning light ON/OFF -
      Indicate Lamp Cruise CRUISE indicator light ON/OFF -
      Indicate Lamp Brake BRAKE warning light ON/OFF -
      Indicate EPS P/S warning light ON/OFF -
      Indicate KEY SMART KEY indicator light ON/OFF -
      Indicate VSC OFF *2 VSC OFF indicator light ON/OFF -
      HINT:
      *1: for Automatic Transaxle
      *2: w/ VSC
      *3. w/ Tire Pressure System
scientia non olet · About LEMON Manuals