Inspection Procedure

1. Connect Techstream to the DLC3..
2. Turn the ignition switch on (IG) and turn the tester ON.
3. Check for DTCs and note any codes that are output (See DTC CHECK / CLEAR  ).
4. Clear the DTC (See DTC CHECK / CLEAR  ).
5. Recheck for DTC (See DTC CHECK / CLEAR  ).

   Result 

   RESULT CHART
   
   

   Result	Proceed to
   DTC output	A
   DTC not output	B

B : USE SIMULATION METHOD TO CHECK  (See HOW TO PROCEED WITH TROUBLESHOOTING )

A: Go To "CAN COMMUNICATION SYSTEM" SYSTEM DESCRIPTION