DTC Check / Clear

CHECK DTC
1. Connect Techstream to the DLC3.
2. Turn the ignition switch on (IG) and turn the tester ON.
3. Enter the following menus: Body Electrical / (desired system) / Trouble Codes.
4. Check for DTCs and then write them down.
  HINT:
  
  Refer to the tester operator's manual for further details.
5. Confirm the details of the DTCs (see DIAGNOSTIC TROUBLE CODE CHART ).
CLEAR DTC
1. Connect Techstream to the DLC3.
2. Turn the ignition switch on (IG) (do not start the engine) and turn the tester ON.
3. Enter the following menus: Body Electrical / (desired system) / Trouble Codes
  HINT:
  
  Refer to the tester operator's manual for further details.
4. Erase DTCs by pressing the YES button on the tester. HINT:
  Refer to the tester operator's manual for further details.