Inspection Procedure

1. Remove the front seat inner belt.
2. Measure the resistance of the belt.

   Standard resistance 

   RESISTANCE SPECIFICATION
   
   

   Tester Connection	Condition	Specified Condition
   1 - 2	Seat belt is fastened	1 MΩ or higher
   1 - 2	Seat belt is not fastened	Below 1 Ω

Fig 1: Identifying Front Seat Inner Belt Terminals (Driver Side)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPLACE FRONT SEAT INNER BELT ASSEMBLY (DRIVER SIDE) 

OK: Go to next step 

1. Disconnect the F7 belt connector.
2. Disconnect the C6 meter connector.
3. Measure the resistance of the wire harness side connectors.

   Standard resistance 

   RESISTANCE SPECIFICATION
   
   

   Tester Connection	Specified Condition
   F7-1 - Body ground	Below 1 Ω
   F7-2 - C6-5	Below 1 Ω
   F7-2 - Body ground	10 kΩ or higher

   Fig 2: Identifying Front Seat Inner Belt And Combination Meter Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS AND CONNECTOR 

OK: REPAIR OR REPLACE COMBINATION METER ASSEMBLY