Data List / Active Test

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

1. Warm up the engine.
2. Turn the ignition switch off.
3. Connect the intelligent tester to the DLC3.
4. Turn the ignition switch ON.
5. Turn the Techstream ON.
6. Enter the following menus:
   1. for Engine and ECT: Powertrain / Engine and ECT / Data List.
   2. for ABS/VSC/TRAC: Chassis / ABS/VSC/TRAC/ Data List.
7. Check the values by refering to the table below.

   ENGINE AND ECT: 

   DATA LIST - ENGINE AND ECT
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Engine Speed	Engine speed/Min.: 0 rpm, Max.: 16383	650 to 750 rpm: Idling (for manual transaxle)	-
   		610 to 710 rpm: Idling (for automatic transaxle)
   Coolant Temp	Coolant temprature/Min.: -40C (40F), Max.: 140C (284F)	After warming up: 80 to 100C (176 to 212F)	*If -40C (-40F):sensor circuit open *If 140C (284F) or more: sensor circuit shorted

   ABS/TRAC/VSC: 

   DATA LIST - ABS/TRAC/VSC
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   FR Wheel Speed	Wheel speed sensor (FR) reading/min.: 0 km/h (0 mph), max.: 326 km/h (202)	Almost the same as actual speed (When driving)	-
   FL Wheel Speed	Wheel speed sensor (FL) reading/min.: 0 km/h (0 mph), max.: 326 km/h (202)	Almost the same as actual speed (When driving)	-
   RR Wheel Speed	Wheel speed sensor (RR) reading/min.: 0 km/h (0 mph), max.: 326 km/h (202)	Almost the same as actual speed (When driving)	-
   RL Wheel Speed	Wheel speed sensor (RL) reading/min.: 0 km/h (0 mph), max.: 326 km/h (202)	Almost the same as actual speed (When driving)	-