LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2008 >> xD Automatic >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> 2ZR-FE Fuel >> Fuel Sender Gauge Assembly >> Removal

Fuel Sender Gauge Assembly: Removal

  1. REMOVE NO. 1 SEAT LEG COVER  (See REMOVAL )
  2. REMOVE NO. 2 SEAT LEG COVER  (See REMOVAL )
  3. REMOVE REAR SEAT ASSEMBLY  (See REMOVAL )
  4. REMOVE REAR FLOOR SERVICE HOLE COVER  (See REMOVAL  )
  5. DISCHARGE FUEL SYSTEM PRESSURE  (See FUEL SYSTEM  )
  6. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY  (See REMOVAL  )
  7. DISCONNECT FUEL TANK VENT HOSE  (See REMOVAL  )
  8. REMOVE FUEL PUMP GAUGE RETAINER  (See REMOVAL  )
  9. REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY  (See REMOVAL  )
  10. REMOVE FUEL SENDER GAUGE ASSEMBLY 
    NOTE: Do not separate the tube indicated in the illustration.
    Fig 1: Locating Fuel Sender Gauge Assembly
    G05399516Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the fuel sender gauge connector.
      Fig 2: Locating Fuel Sender Gauge Connector
      G04833461Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Release the lock by sliding the fuel sender gauge upward, as shown in the illustration.
      Fig 3: Sliding Fuel Sender Gauge
      G04829080Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals