On-Vehicle Inspection
- INSPECT WASHER LEVEL WARNING SWITCH
- Check the operation of the washer level warning switch.
- Fill the washer jar with washer fluid.
HINT:
The operation should be performed with the washer level warning switch installed on the washer jar assembly.
- Check the resistance.
HINT:
Pull out the washer hose connected to the washer motor. Perform the inspection while draining the washer fluid.
Standard resistance
STANDARD RESISTANCE SPECIFICATIONSAmount of remaining washer fluid Specified Condition 600 to 800 ml or more 10 kΩ or higher 600 to 800 ml or less Below 1Ω If the result is not as specified, replace the washer level warning switch.
- Fill the washer jar with washer fluid.
- Check the operation of the washer level warning switch.