Inspection Procedure

1. Connect a Techstream to the DLC3.
2. Turn the ignition switch on and turn the tester on.
3. Check for DTCs and note any codes that are output (See DTC CHECK / CLEAR  ).
4. Clear the DTC (See DTC CHECK / CLEAR  ).
5. Recheck for DTC (See DTC CHECK / CLEAR  ).

   Result 

   RESULT DESCRIPTION
   
   

   Result	Proceed to
   CAN communication DTC is not output	A
   CAN communication DTC is output	B

B: Go to DIAGNOSTIC TROUBLE CODE CHART  (See HOW TO PROCEED WITH TROUBLESHOOTING )

A: Go to Next Step 

1. Connect a Techstream to the DLC3.
2. Turn the ignition switch on and turn the tester on.
3. Check for DTCs and note any codes that are output (See DTC CHECK / CLEAR  ).
4. Clear the DTC (See DTC CHECK / CLEAR  ).
5. Recheck for DTC (See DTC CHECK / CLEAR  ).

   Result 

   RESULT DESCRIPTION
   
   

   Result	Proceed to
   Engine control DTC is not output	A
   Engine control DTC is output	B

B: Go to DIAGNOSTIC TROUBLE CODE CHART  (See HOW TO PROCEED WITH TROUBLESHOOTING )

A: Go to Next Step 

1. Connect a Techstream to the DLC3.
2. Turn the ignition switch on and turn the tester on.
3. Operate the Techstream according to the display and select "Active Test" (See DATA LIST / ACTIVE TEST  ).

   Body Electrical / Combination Meter / Active Test: 

   BODY ELECTRICAL / COMBINATION METER / ACTIVE TEST
   
   

   Tester Display	Test Part	Control Range
   Water Temperature Meter Operation	LOW / NORMAL / HIGH	Value selected during Active Test is displayed

   OK: Value selected during "Active Test" is displayed. 

NG: REPLACE COMBINATION METER ASSEMBLY  (See REMOVAL  )

OK: Go to Next Step 

1. Connect a Techstream to the DLC3.
2. Turn the ignition switch on and the tester on.
3. Operate the Techstream according to the display and select "Data List" (See DATA LIST / ACTIVE TEST  ).

   Body Electrical / Combination meter / Data List: 

   BODY ELECTRICAL / COMBINATION METER / DATA LIST
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Coolant Temperature	Engine coolant temperature Min.: 0 (0) Max.: 127.5 (261.5)	After warning up 75 to 105 (167 to 221)	Unit: °C (°F)

   OK: Vehicle's coolant temperature and tester value are the same. 

NG: REPLACE COMBINATION METER ASSEMBLY  (See REMOVAL  )

OK : USE SIMULATION METHOD TO CHECK  (See HOW TO PROCEED WITH TROUBLESHOOTING )