LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2008 >> xD Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter >> Meter / Gauge System >> Data List / Active Test

Data List / Active Test

  1. READ DATA LIST 

    HINT

    Using the tester's "Data List" allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the "Data List" early in troubleshooting is one way to save time

    1. Connect a Techstream to the DLC3.
    2. Turn the ignition switch on and turn the tester on.
    3. Enter the following menu items: Body Electrical / Combination Meter / Data List.
    4. Check the results by referring to the table below.

      Body Electrical / Combination Meter / Data List: 

      BODY ELECTRICAL / COMBINATION METER / DATA LIST

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Tail Relay SW Taillight relay ON or OFF ON. Headlight dimmer switch (Light control switch) → TAIL
      OFF: Headlight dimmer switch (Light control switch) → OFF      		 -
      Tail Cancel SW Tail cancel switch ON or OFF ON Headlight dimmer switch (Light control switch) → OFF
      OFF Headlight dimmer switch (Light control switch) → TAIL or HEAD      		 -
      ODO/TRIP Change SW ODO/TRIP switch ON or OFF ON: ODO/TIRP switch pushed
      OFF ODO/TIRP switch not pushed      		 -
      Vehicle Speed Meter Vehicle speed
      Min. 0(0)
      Max: 158 (255)      		 Approximately same as vehicle speed (When vehicle is driving) Unit: mph (km/h)
      Engine RPM Engine speed
      Min: 0
      Max. 12, 750      		 Approximately same as actual engine speed Unit, rpm
      Coolant Temperature Engine coolant temperature
      Min. 0
      Max: 127.5 (261.5)      		 After warming up, 75 to 105 (167 to 221) Unit: °C (°F)
      +B Voltage Value Battery voltage
      Min: 0
      Max. 25.5      		 Between 1 V and 14 V Unit. V
      Integrated value for Oil Maintenance Integrated value for Oil Maintenance warning
      Min 0 (0)
      Max. 25500 (41037)      		 0(0) to 25500 (41037) Unit, mile (km/h)
      Fuel Input Fuel sender gauge input
      Min. 0 (0)
      Max: 127.5      		 Fuel sender input value Unit: Liters
      Ambient Temperature Ambient Temperature
      Min: -40 (-40)
      Max -87.5 (189.5)      		 Same as outside temperature Unit °C (°F)
      Rheostat value Rheostat value
      Min. 0
      Max: 100      		 Light control rheostat switch is dark (0) → bright (100) Unit. %
      Quantity of Outside Light Outside dimmer output
      Min. 0
      Max 100      		 0 to 100 Unit %
      Communication ECM/Meter DTC 1 ECM communication stop history Rec or Unrec Displays DTC history -
      ECM ODO (History 1) ECM odometer history
      Min.: 0
      Max. 999999      		 With history : 0 to 999999
      Without history : FFFFFFh      		 -
      Communication ECM/Meter DTC 2 ECM communication stop history Rec or Unrec Displays DTC history -
      ECM ODO (History 2) ECM odometer history
      Min. 0
      Max.: 999999      		 With history : 0 to 999999
      Without history : FFFFFFh      		 -
      Communication ECM/Meter DTC 3 ECM communication stop history Rec or Unrec Displays DTC history -
      ECM ODO (History 3) ECM odometer history
      Min.: 0
      Max: 999999      		 With history 0 to 999999
      Without history : FFFFFFh      		 -
      Communication ABS/Meter DTC 1 Skid control ECU communication stop history
      Rec or Unrec      		 Displays DTC history -
      ABS/VSC ODO (History 1) Skid control ECU odometer history
      Min 0
      Max 999999      		 With history 0 to 999999
      Without history FFFFFFh      		 -
      Communication ABS/Meter DTC 2 Skid control ECU communication stop history
      Rec or Unrec      		 Displays DTC history -
      ABS/VSC ODO (History 2) Skid control ECU odometer history
      Min 0
      Max 999999      		 With history 0 to 999999
      Without history FFFFFFh      		 -
      Communication ABS/Meter DTC 3 Skid control ECU communication stop history
      Rec or Unrec      		 Displays DTC history -
      ABS/VSC ODO (History 3) Skid control ECU odometer history
      Min 0
      Max 999999      		 With history 0 to 999999
      Without history : FFFFFFh      		 -
      Key Remind Sound Key remind sound FAST, NORMAL or SLOW Display key reminder buzzer speed setting -
      D-Seatbelt Warning Buzzer Front driver seat belt warning buzzer
      ON or OFF      		 ON Front driver side seat belt warning buzzer ON setting
      OFF Front driver side seat belt warning buzzer OFF setting      		 -
      P-Seatbelt Warning Buzzer Front passenger seat belt warning buzzer
      ON or OFF      		 ON Front passenger side seat belt warning buzzer ON setting
      OFF Front passenger side seat belt warning buzzer OFF setting      		 -
      Number of Trouble Code The number of the DTC which is currently output - -

      Body Electrical / Main Body / Data List: 

      BODY ELECTRICAL / MAIN BODY / DATA LIST

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      D Door Courtesy SW Driver side door courtesy light switch signal
      ON or OFF      		 ON Driver side door is open
      OFF Driver side door is closed      		 -
      Parking Brake SW Parking brake switch signal ON or OFF ON Parking brake lever is pulled
      OFF Parking brake lever is lowered      		 -
  2. PERFORM ACTIVE TEST 

    HINT:

    Performing the tester's "Active Test" allows relay, VSV, actuator and other items to be operated without removing any parts.

    Performing the "Active Test" early in troubleshooting is one way to save time.

    The "Data List" can be displayed during the "Active Test".

    1. Connect a Techstream to the DLC3.
    2. Turn the ignition switch on and turn the tester on.
    3. Enter the following menu items: Body Electrical / Combination Meter / Active Test.
    4. Perform the "Active Test" by referring to the table below.

      Body Electrical / Combination Meter / Active Test: 

      BODY ELECTRICAL / COMBINATION METER / ACTIVE TEST

      Tester Display Test Part Control Range
      Speed Meter Operation 0 / 64 (40) /129 (80) /193 (120) km/h (mph) Value selected during Active Test is displayed
      Tachometer Operation 0 /1,000 / 2,000 / 3,000 / 4,000 / 5,000 / 6,000 / 7,000 rpm Value selected during Active Test is displayed
      Fuel Meter Operation EMPTY/1/2/FULL Value selected during Active Test is displayed
      A/T Indicator Operation 1 *1 P/R/N/D/3/2/L Position selected during Active Test illuminates
      Meter Display 1 ALL/0/1/2/3/4/5/6 -
      Meter Display 2 7/8/9 -
      Indicat. Lamp Airbag AIR BAG warning light ON / OFF -
      Indicat Lamp Doors All Open DOOR warning light ON / OFF -
      Indicat Lamp P-seat Belt P-BELT warning light ON / OFF -
      Indicat Lamp D-seat Belt D-BELT warning light ON / OFF -
      Indicat. Lamp ABS ABS warning light ON / OFF -
      Indicat Lamp Charge CHARGE indicator light ON / OFF -
      Indicat Lamp Slip *2 SLIP warning light ON / OFF -
      Indicat Lamp Coolant HOT Engine coolant temperature indicator light ON/OFF -
      Indicat Lamp Coolant COOL Engine coolant temperature indicator light ON/OFF -
      Indicat. Tire Pressure Warning System*3 TIRE PRESSURE warning light ON/OFF -
      Indicat Lamp Cruise CRUISE indicator light ON/OFF -
      Indicat Lamp Brake BRAKE warning light ON/OFF -
      Indicat. EPS P/S warning light ON/OFF -
      Indicat. Oil maintenance Oil maintenance indicator light ON/OFF -
      Indicat. VSC OFF *2 VSC OFF indicator light ON/OFF -
      HINT:
      *1: for Automatic Transaxle
      *2: for vehicles with VSC
      *3: for vehicles with Tire Pressure System
scientia non olet · About LEMON Manuals