Inspection Procedure

1. Connect a Techstream to the DLC3.
2. Turn the ignition switch on and turn the tester on.
3. Check for DTCs and note any codes that are output (See DTC CHECK / CLEAR  ).
4. Clear the DTC (See DTC CHECK / CLEAR  ).
5. Recheck for DTC (See DTC CHECK / CLEAR  ).

   Result 

   RESULT DESCRIPTION
   
   

   Result	Proceed to
   DTC output	A
   DTC not output	B

B : USE SIMULATION METHOD TO CHECK  (See HOW TO PROCEED WITH TROUBLESHOOTING )

A: Go to CAN COMMUNICATION SYSTEM  (See HOW TO PROCEED WITH TROUBLESHOOTING )