LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2008 >> tC Spec, Standard >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System >> Driver Side Knee Airbag Assembly >> Installation

Driver Side Knee Airbag Assembly: Installation

CAUTION: Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see PRECAUTION  ).
  1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY 
    1. Connect the connector.
      NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
    2. Install the front passenger side knee airbag with the 3 bolts.

      Torque: 18 N*m (184 kgf*cm, 13 ft.*lbf) 

  2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    Fig 1: Identifying Front Passenger Side Knee Airbag Bolts
    G05541175Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
  4. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (see DIAGNOSIS SYSTEM  ).
scientia non olet · About LEMON Manuals