Inspection Procedure

1. Disconnect the F9 gauge connector.
2. Check the meter indicator condition.

   OK 

   WIRE CONNECTION AND SPECIFIED CONDITION
   
   

   Wire Connection	Condition	Specified Condition
   2 - 3	Short circuit (Ignition switch ON)	Fuel gauge indicator "F" or more (combination meter)

3. Measure the voltage of the wire harness side connector.

   Standard voltage 

   VOLTAGE SPECIFICATION
   
   

   Tester Connection	Condition	Specified Condition
   2 - Body ground	Ignition switch ON	11 to 14 V

   Fig 1: Identifying F9 Fuel Sender Gauge Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: Go to step  3

OK: Go to next step 

1. Remove the fuel sender gauge assembly.
2. Check that the float moves smoothly between F and E.
3. Measure the resistance between terminals 2 and 3 of the gauge.

   Standard resistance 

   RESISTANCE SPECIFICATION
   
   

   Float Level	Specified Condition
   SF	3.0 to 5.0 Ω
   Between E and F	3.0 to 111 Ω
   SE	109 to 111 Ω

Fig 2: Identifying Fuel Sender Gauge Connector Terminals
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPLACE FUEL SENDER GAUGE ASSEMBLY 

OK: REPLACE COMBINATION METER ASSEMBLY 

1. Disconnect the C6 meter connector.
2. Disconnect the F9 gauge connector.
3. Measure the resistance of the wire harness side connectors.

   Standard resistance 

   RESISTANCE SPECIFICATION
   
   

   Tester Connection	Specified Condition
   C6-23 - F9-2	Below 1 Ω
   C6-2 - F9-3	Below 1 Ω

   Fig 3: Identifying Combination Meter And Fuel Sender Gauge Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS AND CONNECTOR 

OK: REPLACE COMBINATION METER ASSEMBLY