Data List / Active Test

HINT:

According to DATA LIST display by the intelligent tester, you can read the values of the switches, sensors, actuators and so on without parts removal. Reading the DATA LIST as the first step of troubleshooting is one method to shorten work time.

1. Warm up the engine.
2. Turn the ignition switch off.
3. Connect the intelligent tester to the DLC3.
4. Turn the ignition switch ON.
5. Operate the intelligent tester according to the step on the display and select "DATA LIST".

   ENGINE: 

   DATA LIST - ENGINE
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   VEHICLE SPD	Vehicle speed/Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)	Almost the same as the actual vehicle speed (When driving)	-
   ENGINE SPD	Engine speed/Min.: 0 rpm, Max.: 16,282 rpm	Almost the same as the actual engine speed (When engine is running)	-
   COOLANT TEMP	Coolant temperature/Min.: -40°C (40°F), Max.: 140°C (284°F)	After warming up: 80 to 95°C (176 to 203°F)	If the value is "-40°C (-40°F)" or "140°C (284°F)", sensor circuit is open or shorted

   ABS/TRAC/VSC: 

   DATA LIST - ABS/TRAC/VSC
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   (FR/FL/RR/RL) WHEEL SPD	Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)	Almost the same as actual speed (When driving)	-