LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2008 >> tC Base, Automatic >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System >> Steering Pad >> Removal

Steering Pad: Removal

  1. PRECAUTION 
    CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing (See PRECAUTION  ).
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Work must be started at least 90 seconds after the ignition switch is turned off and after the cable is disconnected from the negative (-) battery terminal.
  3. REMOVE STEERING PAD ASSEMBLY 
    1. Using a "TORX" socket (T30), loosen the 2 "TORX" screws until the groove along the screw circumference catches on the screw case.
      Fig 1: Identifying TORX Screws
      G05541144Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand.
      NOTE: When removing the steering pad, do not pull the airbag wire harness.
    3. Disconnect the horn connector from the steering pad.
    4. Disconnect the 2 airbag connectors and remove the steering pad.
      CAUTION: When handling the airbag connector, take care not to damage the airbag wire harness.
    5. Remove the steering pad.
      Fig 2: Identifying Pulling Out Steering Pad From Steering Wheel Assembly And Support Steering Pad With One Hand
      G05541145Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals