LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2008 >> tC Base, Automatic >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System >> Front Passenger Airbag Assembly >> Installation

Front Passenger Airbag Assembly: Installation

CAUTION: Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see PRECAUTION  ).
  1. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY 
    1. Install the front passenger airbag assembly with the 2 screws.
      2. Fig 1: Identifying Front Passenger Airbag Assembly Screws
      G05541195Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the connectors to the airbag.
    3. Install the clip.
    4. Install the instrument panel sub-assembly upper (see INSTALLATION ).
    5. Connect the connector to the airbag.
      NOTE: When handling the airbag connector, do not damage the airbag wire harness.
      6. Fig 2: Identifying Connector To Airbag
      G05541196Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY  (See INSTALLATION )
  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  4. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
  5. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (see DIAGNOSIS SYSTEM  ).
scientia non olet · About LEMON Manuals